PIEPS PRO BT Instructions page 13

4.5.2 PIEPS iPROBE-Support
Beacons with iPROBE-support* get automatically deactivated when probing with the electronic probe PIEPS
iPROBE. This prevents signal overlaps and the next-strongest signal is automatically shown on the display of the
receiving beacon. Maximum support in multiple burials!
* Beacons with iPROBE-Support: PIEPS PRO BT/POWDER BT, PIEPS MICRO, PIEPS DSP PRO/SPORT/PRO ICE, PIEPS
DSP STANDARD/TOUR ≥ v5.0, PIEPS FREERIDE, BLACK DIAMOND GUIDE/RECON.
4.6 SEND  SEARCH
Move the slider lock (1C) to the left and the slider (1B) upwards in the position SEARCH.
4.7 SEARCH  SEND
Move the slider (1B) downwards, until it locks in the position SEND.
4.7.1 Secondary avalanche | Auto-Search-to-Send
The PIEPS PRO BT/POWDER BT provides the feature Auto-Search-to-Send. By default, it is disabled and can be
enabled in the PIEPS APP device manager. Once enabled, the device switches from search mode to send mode
automatically after a certain time without motion (burial).
The function provides the following characteristics:
•
Motion-controlled initialization
•
Short switching timeout
•
Long warning phase with alert and countdown prior to switching
•
Continued alert, also after switching
Beacon
SEARCH
function
Display
Search display
indication
Sound Search sound
Manual abort
Setting 1 (60 s)
Setting 2 (90 s)
Setting 3 (120 s)
Manual PIEPS PRO BT/POWDER BT | Firmware v1.0 | 08/2018
Turn device or press MARK button
START WARNING
0:30 min
1:00 min
1:30 min
WARNING
SWITCHING TO SEND
1:00 min
1:30 min
2:00 min
SEND
Turn device off or into send mode
12 / 22