Table des Matières
Publicité
4.9 PIEPS PRO BT FEATURES
4.9.1 Vibra support
Send-Vibra: see chapter 4.3.
Vibra on initial signal detection: see chapter 4.8.2.
4.9.2 Extended group check & pro-mode
See chapter 4.4.
4.9.3 Mark range settings
In the PIEPS APP device manager the mark range can be changed from 5 m (default) to 20 m or to max. range.
4.9.4 Inclinometer
You can use the integrated three dimensional inclinometer to quickly check the gradient:
•
Put your ski pole in slope line at that point of the slope you want to measure.
•
Press the button SCAN (1E) for 3 seconds while in send mode.
•
Put your PIEPS PRO BT next to the ski pole and read the indicated value. The display
switches back to send mode indication automatically after 20 seconds.
DANGER
Risk of device loss during slope angle measurement
Although the PIEPS PRO BT keeps transmitting while the inclinometer is active, the function
should only be used for training reasons. Never use the inclinometer function in avalanche
terrain!
4.9.5 SCAN & victim selection
Two SCAN modes are available:
The Regular SCAN provides a rough overview about the burial situation by indicating the number of victims within
certain distance ranges. This is the default setting. The Detailed SCAN shows direction and distance for each
victim and allows selecting a victim. The setting can be changed in the PIEPS APP device manager.
Regular SCAN
Press the button SCAN (1E) while in search mode.
The PIEPS PRO BT scans the entire receiving range
and displays an overview. During the scan, don´t
move and hold the device steady.
reading 1: total number of victims within 5 m
reading 2: total number of victims within 20 m
reading 3: total number of victims within 60 m
The SCAN mode ends automatically but can also be
interrupted by another SCAN button press.
Manual PIEPS PRO BT/POWDER BT | Firmware v1.0 | 08/2018
17 / 22
Publicité
Table des Matières
