4.2 CARRYING SYSTEM
PIEPS recommends using the included carrying system (3A) or an
approved apparel pocket. In order to protect the beacon's display,
carry the beacon with its display facing inwards (3B). The transmit
control LED (1G) is visible in the pouch´s window (3C).
The included hand loop is intended to be used for training sessions.
DANGER
Risk of device loss
Always carry the device in the included carrying system or an approved apparel pocket!
Always leave the device cord-secured!
4.3 SWITCHING ON | SELF-CHECK | SEND MODE
Switching on: Move the slider lock (1C) to the left and the slider (1B) upwards into the position SEARCH. Then
release the slider lock (1C) and move the slider (1B) downwards, until it locks in the position SEND.
The display shows firmware version, battery capacity, self-check progress (4A), self-check result (4B), group check
countdown (4C) and finally the send display with the active transmitting antenna (4D).
The device is now in send mode, the transmit control LED (1G) is blinking.
NOTICE
A minimum distance of 5 m from other devices and all electronic, magnetic and metallic sources
of interference should be kept during the self-check.
If the self-check is successful, "OK" is indicated on the display (4B). In the event of a device warning, an alert signal
sounds and the display indicates "E" in combination with a number (4E). For error codes, see chapter 6.1.
4A
Firmware version
Battery capacity/type
(AL=Alkaline, LI=Lithium)
Send-Vibra
Additionally, the PIEPS PRO BT provides haptic send mode confirmation (10x vibration).
This feature is enabled by default and can be disabled in the PIEPS APP device manager.
Manual PIEPS PRO BT/POWDER BT | Firmware v1.0 | 08/2018
4B
4C
Self-check OK
Group check
countdown
4D
4E
SEND display
Self-check error
9 / 22