SEAL 54 EL Mode D'emploi page 28

7
TROUBLESHOOTING
List of common problems and solutions that the user can correct:
Problem
The power LED does not come
on, when the machine is
switched on.
Both the forward and the
reverse LED is flashing
Forward LED or reverse LED is
flashing
For technical assistance, please contact your technical service representative (see 8.2)
7.1 Troubleshooting Processes
During processing wrinkles can show up in the image (1) on the in-feed table (2) and in the process
result (4) on the output table.
The figures below show some examples where it is caused by the main rollers (3) and gives a
possible solution.
Wait until a few meters are processed to see results.
For best results, always work in the center of the machine.
Pressure too high.
Figure 21: Wrinkles due to high pressure.
•
Contact your dealer and ask for technical assistance.
24
cause
There is no power
The voltage from the
motor power supply is
too low or too high
Drive-motor is in
overload
solution
Check if the power cable is
plugged into the mains wall outlet.
Check main power fuse by the
power inlet.
Reset the power
Call your service technician.
Stop then restart the machine.
Turn down the film tension.