SEAL 54 EL Mode D'emploi page 117

8
PROCESS CONTROL SHEET
Note: We recommend that you make a photocopy of this page. With each successfully run
application, record the process and settings and a diagram of the webbing procedure. Keep the
record so the application can be repeated at a later date.
If a standard image is made available for each new process then sales materials and
samples can be developed for reference.
LAMINATOR SETTINGS
Media:
_____________________________________
_____________________________________
_____________________________________
Process: ______________________________
Application Use: ________________________
Upper Unwind Shaft:_____________________
Lower Unwind Shaft:_____________________
Wind-up Tube: _________________________
Motor Speed Setting: ____________________
WEBBING SETTINGS
Web Tension Upper Unwind Shaft:
Light / Med. / Heavy _____________________
Web Tension Lower Unwind Shaft:
Light / Med. / Heavy _____________________
Nip Height: ____________________________
Figure 25: Blank Webbing Diagram
113