Unpacking And Installation; Ambient Conditions - SEAL 54 EL Mode D'emploi

3

UNPACKING AND INSTALLATION

Please read and fully understand the entire manual before proceeding to use your laminator.

3.1 Ambient Conditions

The following environmental conditions are ideal for the best operation of the laminator.
Ambient Temperature
The best temperature for the 54/65 EL is between 16°C and 35°C (50°F and 95°F).
Do not expose the laminator to direct sunlight as output quality may be affected.
Relative humidity
For best results, the ambient relative humidity for the 54/65 EL should lie between 50% and 70%.
Water and moisture
If the laminator is installed in a damp room or near water, the electrical power supply must be in
accordance with the standards of the area.
3.2 Surroundings
Install the laminator in surroundings that are as clean and dust free as possible in order to obtain the
highest quality end product. The materials that are used on this laminator can have an electrostatic
charge and will attract dust, adversely affecting the output.
3.3 Power supply
Connect the machine in accordance with the details given on the identification plate attached to the
rear of the machine. Refer also to the technical specifications in this section for more information.
3.4 Workspace Requirements
•
This unit should be situated away from heat sources such as heat registers or stoves.
•
The laminator's location or position should not interfere with its proper ventilation.
•
There should be enough space around the laminator to feed-in, exit, and trim mounted and/or
laminated images.
•
The background dust level must not exceed that found in a typical office/computer room
environment.
•
The work area should be level, flat, and well lit.
6