User Interface - AERMEC VMF-E3 Manuel

2.

USER INTERFACE

Operating mode
selector
3. COMMANDS
The setpoint temperature selector can adjust the setpoint on the basis of the operating mode (heating/air conditioning). The temperature range for defi ning the working
setpoint, in relation to the working band selected on the thermostat, is as follows:
Operation
Heating
Cooling
Deviation with
supervisor
The operating mode selector can be set as follows:
Selector
OFF The thermostat is switched off . It can start up in heating mode however, if the room temperature falls below 7°C and the water temperature is suitable
(anti-freeze function)
AUTO The thermostat autonomously selects the fan speed in relation to the deviation between the room temperature and the operating setpoint
V1 The thermostat works at speed V1 (minimum), regardless of the deviation between the room temperature and the operating setpoint
V2 The thermostat works at speed V2 (average), regardless of the deviation between the room temperature and the operating setpoint
V3 The thermostat works at speed V3 (maximum), regardless of the deviation between the room temperature and the operating setpoint
The thermostat autonomously selects the fan speed in relation to the deviation between the room temperature and the operating setpoint, and also
AUX
enables the accessory confi gured (heater or air purifying device)
Band Minimum
--- 12°C
Normal 14°C
Reduced 17°C
Normal -6°C
Reduced -3°C
BLUE/RED WHITE/GREEN
LED LED
Maximum
28°C
30°C
33°C
The type of band is selected with the dip switches on the thermo-
stat that the VMF-E3 panel is connected to.
+6°C
+3°C
Operation
Setpoint
temperature selector
Notes
---