Conrad GX107 Mode D'emploi page 82

If you would like to stop at an earlier point of time without receiving all of the SMS messages
programmed from the "GX107", send the command:
RESET GPS #1513
or RESET GPSMAP #1513
GPS Zone
The "GX107" with a GPS module attached can be used for zone monitoring. After programming
the permissible zone(s) (no more than 10) and after activating the alarm mode ("ENABLE"),
any exceeding of the permissible zone(s) will trigger an alarm message with the current GPS
coordinates to all stored phone numbers and email addresses.
Note: The map is taken from the OpenStreetMap project!

When the input voltage is connected, the current location is checked every
second. If the "GX107" is supplied by the internal rechargeable battery, the
current site is updated every hour to save power.
If the "GX107" changes its position (change of the GSM radio cell BTS) or if the "GX107"
receives the "TEST GPS" command, the current GPS location is updated. This interval can be
changed with the following command:
SET GPSSAVE <Time in Minutes> #1513
82
All manuals and user guides at all-guides.com