afx light LAS1000RGB-5IN1 Manuel D'utilisation page 33

SOUND ACTIVATED MODE: Sensitivity Setting

Press FUNC until S 6 is displayed

Press UP/DOWN to set the microphone sensitivity. S 0 is no sound activation, from S 1 to S 9, the sensitivity level is
getting more sensitive.

Press ENTER to confirm and save the setting.
DMX Control
Press FUNC to enter MODE selection

Press until the LCD panel shows 001

Press ENTER to confirm setting

The laser is working in DMX MODE. Set the DMX address via the UP and DOWN buttons
Slave Operation
Press FUNC to enter MODE selection

Press until the LCD panel shows SLAVE

Press ENTER to confirm setting

The laser is working in SLAVE MODE. Connect MASTER laser to several SLAVE lasers via a DMX cable, SLAVE
lasers are doing exactly the same laser show as MASTER laser. Please check below for DMX cable connection for
reference.
DMX512
1. Instale as unidades numa posição adequada (fixa ou anexar).
2. Use cabos de microfone XLR em rede com as unidades em conjunto através da tomada XLR na parte traseira
das unidades. Para mais cabo sugerimos um terminal na última ligação.
3. Atribua um endereço DMX para cada unidade usando dipswitches; Consulte a secção "DMX Address Quick
Reference Char». (Todas as unidades definidas para # 1 e # 10 vão ficar OK)
4. Ligue a alimentação de todas as unidades, as unidades começam a reconfigurar, e em seguida, a unidade
começa a trabalhar.
5. Use a consola DMX para controlar as unidades.
PATTERN MIRROR REVERSE SETTING
Press FUNC to enter MODE selection

Till to below LCD display is shown in LCD panel and the laser will show pattern right side.

Press ENTER to confirm the setting.

With help of UP button, the laser scanned world in x direction could be reversed, as the graphic as below.

With help of DOWN button, the laser scanned world in y direction could be reversed, as the graphic as below.

Please note: Besides the LCD programmed mirror reverse setting, the laser scanned world could be
set by ILDA control panel.
ILDA Control Mode
This unit has an ILDA DB25 port that allows the unit to be PC-controlled. When a 25-pin lead is connected, the

laser will be PC controlled. When the lead is disconnected, the laser will return to the last operating mode.
©Copyright Lotronic 2014
All manuals and user guides at all-guides.com
LAS1000RGB-5IN1 33