SOUNDMASTER UR8600 Manuel page 9

Backup system
• The radio is equipped with a backup system. It requires a 3 V lithium battery (type: CR2032).
Insert the battery into the battery compartment and make sure the positive and negative (+
or -) sides of the battery are in contact with the corresponding terminals in the battery
compartment (18).
• If a power cut occurs, the radio automatically switches to the battery power supply and
keeps the clock and timer settings.
• To open the battery compartment, use a screwdriver to detach the screw on the
compartment door.
• When replacing the battery, do not disconnect the power adapter. Otherwise, all clock and
alarm settings will be lost.
Setting the clock
In standby mode, press and hold the "CLOCK" button (5) until the year starts to flash.
• Setting year: Press the ◄◄ or ►► button (3 or 4).
Press the "CLOCK" button (5) to enter the date setting.
• Setting month/day: Press the ◄◄ button (3) to set the month and the ►► button (4) to set
the day.
• Press the "CLOCK" button (5) to enter the time setting.
• Setting the time: Press the ◄◄ button (3) button to set the hour time and ►► button (4) to
set the minute time.
• Press the "SET" button (5) to confirm each setting option.
Using the antenna
Unroll and extend the antenna (19) to improve FM signal reception.
Listening to radio
1. Press the "POWER" button (8) to switch the radio on.
2. Press the ◄◄ or ►► button (3 or 4) to adjust frequency.
3. Press and hold the ◄◄ or ►► button (3 or 4) to automatically tune to the next available FM
station.
4. Press the "POWER" button (8) to switch the radio off.
Controlling the sound volume
While listening to the radio, press the "VOL UP" (7) or "VOL DOWN" (6) button to control the
volume.
Setting preset stations
You can store up to 10 preset stations.
1. Tune to a station.
2. Press and hold the "MEM/M+" button (5) until "P01" (or the next available preset slot) shows
on the display.
3. Press the ◄◄ or ►► button (3 or 4) to select a preset number (P01-P10).
4. Press the "SET" button (5) to confirm. The preset station has been set up.
5. Press the "MEM/M+" button repeatedly while listening to the radio to select a preset station.
Alternatively, press the "MEM/M+" button (5) once and then press the ◄◄ button (3) or ►►
button (4) to select a preset station.
UR8600 / English Instruction Manual
2