1. General Instructions
We thank you for choosing one of our products. For the best results with your oven, you should read
this manual carefully and retain it for future reference. Before installing the oven, take note of the serial
number so that you can give it to customer service staff if any repairs are required. Having removed
the oven from its packaging, check that it has not been damaged during transportation. If you have
doubts, do not use the oven and refer to a qualified technician for advice. Keep all of the packaging
material (plastic bags, polystyrene, nails) out of the reach of children. When the oven is switched on
for the first time, strong smelling smoke can develop, which is caused by the glue on the insulation
panels surrounding the oven heating for the first time. This is absolutely normal and, if it occurs, you
should wait for the smoke to dissipate before putting food in the oven. The manufacturer accepts no
responsibility in cases where the instructions contained in this document are not observed.
NOTE: the oven functions, properties and accessories cited in this manual will vary, depending on the
model you have purchased.
1.1 Safety Indications
Only use the oven for its intended purpose, that is only for the cooking
of foods; any other use, for example as a heat source, is considered
improper and therefore dangerous. The manufacturer cannot be held
responsible for any damage resulting from improper, incorrect or
unreasonable usage.
The use of any electrical appliance implies the observance of some
fundamental rules:
- do not pull on the power cable to disconnect the plug from the socket;
- do not touch the appliance with wet or damp hands or feet;
- in general the use of adaptors, multiple sockets and extension cables
is not recommended;
- in case of malfunction and/or poor operation, switch off the appliance
and do not tamper with it.
1.2 Electrical Safety
ENSURE THAT AN ELECTRICIAN OR QUALIFIED TECHNICIAN
MAKES THE ELECTRICAL CONNECTIONS.
The power supply to which the oven is connected must conform with
the laws in force in the country of installation. The manufacturer
accepts no responsibility for any damage caused by the failure to
observe these instructions. The oven must be connected to an
electrical supply with an earthed wall outlet or a disconnector with
multiple poles, depending on the laws in force in the country of
installation. The electrical supply should be protected with suitable
fuses and the cables used must have a transverse section that can
ensure correct supply to the oven.
CONNECTION
The oven is supplied with a power cable that should only be connected
to an electrical supply with 220-240 Vac 50 Hz power between the
phases or between the phase and neutral. Before the oven is
connected to the electrical supply, it is important to check:
- power voltage indicated on the gauge;
- the setting of the disconnector.
The grounding wire connected to the oven's earth terminal must be
connected to the earth terminal of the power supply.
WARNING
Before connecting the oven to the power supply, ask a qualified
electrician to check the continuity of the power supply's earth terminal.
The manufacturer accepts no responsibility for any accidents or other
problems caused by failure to connect the oven to the earth terminal or
by an earth connection that has defective continuity.
NOTE: as the oven could require maintenance work, it is advisable to
keep another wall socket available so that the oven can be connected
to this if it is removed from the space in which it is installed. The power
cable must only be substituted by technical service staff or by
technicians with equivalent qualifications.
1.3 Recommendations
After each use of the oven, a minimum of cleaning will help keep the
oven perfectly clean.
Do not line the oven walls with aluminium foil or single-use protection
available from stores. Aluminium foil or any other protection, in direct
contact with the hot enamel, risks melting and deteriorating the enamel
of the insides. In order to prevent excessive dirtying of your oven and
the resulting strong smokey smells, we recommend not using the oven
at very high temperature. It is better to extend the cooking time and
lower the temperature a little. In addition to the accessories supplied
with the oven, we advise you only use dishes and baking moulds
resistant to very high temperatures.
1.4 Installation
The manufacturers have no obligation to carry this out. If the
assistance of the manufacturer is required to rectify faults arising from
incorrect installation, this assistance is not covered by the guarantee.
The installation instructions for professionally qualified personnel must
be followed. Incorrect installation may cause harm or injury to people,
animals or belongings. The manufacturer cannot be held responsible
for such harm or injury.
The oven can be located high in a column or under a worktop. Before
fixing, you must ensure good ventilation in the oven space to allow
proper circulation of the fresh air required for cooling and protecting the
internal parts. Make the openings specified on last page according to
the type of fitting.
1.5 Waste management and environmental protection
This appliance is labelled in accordance with European
Directive 2012/19/EU regarding electric and electronic
appliances (WEEE). The WEEE contain both polluting
substances (that can have a negative effect on the
environment) and base elements (that can be reused). It is
important that the WEEE undergo specific treatments to
correctly remove and dispose of the pollutants and recover
all the materials. Individuals can play an important role in ensuring that
the WEEE do not become an environmental problem; it is essential to
follow a few basic rules:
- the WEEE should not be treated as domestic waste;
- the WEEE should be taken to dedicated collection areas managed by
the town council or a registered company.
In many countries, domestic collections may be available for large
WEEEs. When you buy a new appliance, the old one can be returned
to the vendor who must accept it free of charge as a one-off, as long as
the appliance is of an equivalent type and has the same functions as
the purchased appliance.
SAVING AND RESPECTING THE ENVIRONMENT
Where possible, avoid pre-heating the oven and always try to fill it.
Open the oven door as infrequently as possible, because heat from the
cavity disperses every time it is opened. For a significant energy
saving, switch off the oven between 5 and 10 minutes before the
planned end of the cooking time, and use the residual heat that the
oven continues to generate. Keep the seals clean and in order, to avoid
any heat dispersal outside of the cavity. If you have an electric contract
with an hourly tariff, the "delayed cooking" programme makes energy
saving more simple, moving the cooking process to start at the
reduced tariff time slot.
1.6 Declaration of compliance
By placing the
compliance to all relevant European safety, health and environmental
requirements which are applicable in legislation for this product.
With this the Candy Hoover Group, declares that this appliance
marked with
complies with the essential requirements of the
Directive 2014/53/EU.
To receive a copy of the declaration of conformity, please contact the
manufacturer at: www.candy-group.com.
EN 05
mark on this product, we are confirming