•
Dust blowing out from the indoor unit.
This is happens when the air conditioner has not
been used for a long time or during its first use.
•
Smell emitting from the indoor unit.
This is caused by the indoor unit giving off smells
permeated from building materials, furniture,or
smoke.
•
The air conditioner turns to FAN ONLY mode
from COOL or HEAT
models only) mode.
When the indoor temperature reaches the set
temperature setting, the compressor will stop
automatically, and the air conditioner turns to FAN
only mode. The compressor will start again when the
indoor temperature rises on COOL mode or falls on
HEAT mode to the set point.
Droplets of water may form on the surface of the
indoor unit when cooling occurs in relatively high
humidity (defined as higher than 80%). Adjust the
horizontal louver to the maximum air outlet position
and select HIGH fan speed.
Energy Saving Tips
•
DO NOT set the unit to excessive temperature levels.
•
While cooling, close the curtains to avoid direct sunlight.
•
Doors and windows should be kept closed to keep cool or warm air in the room.
•
DO NOT place objects near the air inlet and outlet of the unit. This will reduce the efficiency of the
unit.
•
Set a timer and use the built-in SLEEP/ECONOMY mode if applicable.
•
If you don't plan to use the unit for a long time, remove the batteries from the remote control.
•
Clean the air filter every two weeks. A dirty filter can reduce cooling or heating efficiency.
Adjust louvers properly and avoid direct airflow.
•
Closing curtains during heating also helps
keep the heat in
(for cooling and heating
•
Heating mode
only)
The air conditioner draws in heat from the outdoor
unit and releases it via the indoor unit during
heating. When the outdoor temperature falls, heat
drawn in by the air conditioner decreases
accordingly. At the same time, heat loading of the air
conditioner increases due to larger difference
between indoor and outdoor temperature. If a
comfortable temperature cannot be achieved with
the air conditioner alone, it is recommended that you
use a supplementary heating device.
Lightning or a car wireless telephone operating
nearby may cause the unit to malfunction.
Disconnect the unit from its power source and then
re-connect the unit with the power source again.
Push the ON/OFF button on the remote controller to
restart operations.
Doors and windows should be kept closed
23
(For cooling and heating models