Product Dimensions; Cabinet Dimensions - Jenn-Air JGR8895BDS Instructions Pour L'installation

In Canada, the installation of this range must conform with the
current standards CAN/CSA-A240-latest edition, or with local
codes.
Mobile home installations require:
When this range is installed in a mobile home, it must be
secured to the floor during transit. Any method of securing
the range is adequate as long as it conforms to the standards
listed above.

Product Dimensions

A
F
A. 35⁷⁄₈" (91.1 cm) cooktop height
(minimum) with leveling legs
screwed all the way in*
B. Model/serial/rating plates
(located behind the control
panel)**
*Range can be raised approximately 1" (2.5 cm) by adjusting
the leveling legs.
**Model/serial/rating plates may be rotated up from behind the
control panel for viewing from the front of the range.
***Excludes handle. Dimension given is from wall to front of oven
door and will vary based on electric outlet receptacle
installation.

Cabinet Dimensions

Cabinet opening dimensions shown are for 25" (64.0 cm)
countertop depth, 24" (61.0 cm) base cabinet depth and
36" (91.4 cm) countertop height.
IMPORTANT: If installing a range hood or microwave hood
combination above the range, follow the range hood or
microwave hood combination installation instructions for
dimensional clearances above the cooktop surface.
Range may be installed with zero clearance to combustible
construction at the rear and on the sides below the cooktop.
4
All manuals and user guides at all-guides.com
B*
C**
D
E***
C. 46³⁄₄" (118.7 cm) overall height
(minimum) with leveling legs
screwed all the way in*
D. 28¹⁄₈" (71.3 cm) depth with
handle
E. 26⁵⁄₁₆" - 27¼" (66.8 - 69.2 cm)***
F. 29⁷⁄₈" (75.9 cm) width
C
A
F
I
9¼"
(23.5 cm)
(7.6 cm)
3½"
(8.9 cm)
3"
(7.6 cm)
1"
(2.5 cm)
A. 18" (45.7 cm) upper cabinet to countertop
B. 13" (33.0 cm) upper cabinet depth
C. 30" (76.2 cm) min. opening width
D. For minimum clearance to the top of the cooktop, see NOTE.
E. 30" (76.2 cm) min. opening width
F. 3" (7.6 cm) min. clearance from both sides of the range to the side
wall or other combustible material.
G. 3" (7.6 cm) distance from wall
H. Cabinet door or hinges should not extend into the cutout.
I. Clearance for gas pressure regulator
*Drill on centerline 1¼" (3.1 cm) from rear wall for gas supply
line.
**Gas lines and electrical plugs must be installed within the
shaded area to ensure proper alignment of this oven with
cabinets.
NOTE: 24" (61.0 cm) minimum when bottom of wood or metal
cabinet is protected by not less than ¹⁄₄" (0.64 cm) flame retardant
millboard covered with not less than No. 28 MSG sheet steel,
0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or
0.020" (0.5 mm) copper.
30" (76.2 cm) minimum clearance between the top of the cooking
platform and the bottom of an unprotected wood or metal
cabinet.
D
B
E
H
G
8¼"
(21.0 cm)
3"
10"
(25.4 cm)
5"
(12.7 cm)
2¼"**
(5.7 cm)
1¼"*
(3.1 cm)
15" (38.1 cm)
gas line location
3½"
(8.9 cm)
H