Oregon Scientific BPU321OS Mode D'emploi page 12

Delete a record:
1. Swipe to left on a record, displays on the record.
2. Tap on to confirm the deletion.
UNIQUE DEVICE ID
Each unit has a unique device ID which can be found on
the device. You can find it on the battery compartment.
TROUBLESHOOTINg
This section includes a list of error messages and
frequently asked questions for problems you may
encounter with your blood pressure monitor. If the product
is not operating as you think it should, check here before
arranging for servicing.
ERROR
Message
CODE
There is an
error during
Err
synchronization
The upper arm cuff
is not appropriately
Err 1
secured.
The monitor detects
motion during
Err 4
meausrement.
Pressure is over
Err 5
300 mmhg
BPU321OS_UM_EN_R20.indd 12
Reason/Suggestion
Repeat the
synchronization
procedure
Refasten the cuff and then
take a measurement again
Do not move or talk during
measurement. Please try
again.
Relax for a moment and
then take a measurement
again
12
Internal software/
EE (3-20)
hardware error
BLE Err
(animated and There is an error
displayed during the
on the top of connection.
screen)
The connection is
BLE Done
successfully done.
frequently asked questions for problems you may
encounter with your blood pressure monitor. If the product
is not operating as you think it should, check here before
arranging for servicing.
SaFETY aND CaRE INSTRUCTIONS
SaFETY PRECaUTIONS
Please observe the following safety precautions when
setting up and using your blood pressure monitor.
• This device is intended for adult use only.
• This device is intended for non-invasive measuring
and monitoring of arterial blood pressure. It is not
intended for use on extremities other than the
upper arm or for functions other than obtaining a
blood pressure measurement.
• Do not confuse self-monitoring with self-diagnosis. This
unit allows you to monitor your blood pressure. Do not
begin or end medical treatment based solely on the
measurements of this device. Consult a physcian for
treatment advice.
Please remove the batteries
and then re-install them
for reset. If the error code
still displays on the screen,
please contact our Customer
Service for a solution.
13-12-5 1:46