Multitab Function - Kuppersbusch IGV6507.1 Notice D'utilisation

32
2. Fill the detergent dispenser (A) with de-
tergent. The marking shows the dosage:
20 = approximately 20 g of detergent
30 = approximately 30 g of detergent.
3. If you use a washing programme with
prewash phase, put more detergent in
the prewash detergent compartment (B).
A
B

Multitab function

The multitab function is for combi detergent
tablets.
These tablets contain agents such as deter-
gent, rinse aid and dishwasher salt. Some
types of tablets can contain other agents.
Do a check if these tablets are applicable for
the local water hardness. Refer to the in-
structions from the manufacturer.
When you set the multitab function, it stays
on until you deactivate it.
The multitab function stops automatically the
flow of rinse aid and salt. The rinse aid indi-
cator light and salt indicator light are deacti-
vated.
All manuals and user guides at all-guides.com
4. If you use detergent tablets, put the de-
5. Close the lid of the detergent dispenser.
The programme duration can increase if you
use the multitab function.
To activate the multitab function:
• Press the multitab button. The multitab in-
To deactivate the multitab function:
tergent tablet in the detergent dispenser
(A).
Press the lid until it locks into position.
Different brands of detergent dissolve in
different times. Some detergent tablets
do not have the best cleaning results
during short washing programmes. Use
long washing programmes when you
use detergent tablets to fully remove the
detergent.
Activate or deactivate the multitab func-
tion before the start of a washing pro-
gramme.
You cannot activate or deactivate the
multitab function when the programme
operates. Cancel the washing pro-
gramme, then set the programme again.
dicator light comes on.