Use Of The Appliance; Setting The Water Softener - Kuppersbusch IGV6507.1 Notice D'utilisation

26
– Indicator lights for function buttons A
and B go off.
– Indicator light for function button C
flashes.
– The digital display shows the setting.
Audible signals deactiva-
ted
Audible signals activated
The audible signals are activated.

Use of the appliance

Refer to the following instructions for each
step of procedure:
1. Make a check if the water softener level
is correct for the water hardness in your
area. If necessary set the water softener.
2. Fill the salt container with dishwasher salt.
3. Fill the rinse aid dispenser with rinse aid.
4. Load cutlery and dishes into the dish-
washer.

Setting the water softener

The water softener removes minerals and
salts from the water supply. Minerals and
salts can have bad effect on the operation of
the appliance.
Water hardness is measured in equivalent
scales:
• German degrees (dH°).
Water hardness
°dH °TH
51 - 70 91 - 125
43 - 50 76 - 90
37 - 42 65 - 75
29 - 36 51 - 64
23 - 28 40 - 50
19 - 22 33 - 39
15 - 18 26 - 32
11 - 14 19 - 25
4 - 10 7 - 18
< 4 < 7
1) No use of salt required.
You must set the water softener man-
ually and electronically.
All manuals and user guides at all-guides.com
6. Press the function button C again.
7. Switch off the appliance to save the op-
Do these steps to activate the audible sig-
nals:
1. Do the above procedure until the digital
5. Set the correct washing programme for
6. Fill the detergent dispenser with the cor-
7. Start the washing programme.
• French degrees (°TH).
• mmol/l (millimol per litre - international unit
• Clarke.
Adjust the water softener to the water hard-
ness in your area. If necessary, contact your
local water authority.
mmol/l Clarke
9,1 - 12,5 64 - 88
7,6 - 9,0 53 - 63
6,5 - 7,5 46 - 52
5,1 - 6,4 36 - 45
4,0 - 5,0 28 - 35
3,3 - 3,9 23 - 27
2,6 - 3,2 18 - 22
1,9 - 2,5 13 - 17
0,7 - 1,8 5 - 12
< 0,7 < 5
Manual adjustment
1. Open the door.
– The digital display shows the new set-
ting.
The audible signals are deactivated.
eration.
display shows necessary setting.
the type of load and soil.
rect quantity of detergent.
If you use combi detergent tablets ('3 in
1', '4 in 1', '5 in 1', etc.), refer to the
chapter 'Multitab function'.
for the hardness of water).
Water hardness setting
manually
2
2
2
2
2
2
1
1
1
1)
1
The appliance is set at the factory at po-
sition 2.
electronically
10
9
8
7
6
5
4
3
2
1)
1