User Maintenance Instructions - BaByliss PRO BAB831C Directives D'utilisation

VERy IMPORTANT: The blade must be cleaned and oiled
before, during and after each use with the provided
cleaning brush and lubricating oil for proper functioning.
HOW TO USE COMB ATTACHMENTS
1. To use the comb attachments, always turn the appliance to
"O-OFF" position.
2. Slide the comb attachment onto the front of the trimmer blade
and snap over the back of the blade.
3. To remove, push up the comb attachment at the back of the
blade and remove the comb.
4. Two comb attachments: 1/8" (3 mm) and 1/4" (6 mm) are
available for this trimmer.
Confirm the voltage (100-240 V) available at each overseas location before using this
trimmer. For connection to the Class 2 Power Supply, model CA01M outlet adaptor
(included) should be used to plug into the power socket with proper configuration.

USER MAINTENANCE INSTRUCTIONS

MAINTENANCE OF THE BLADE
Always apply oil to the blade before, during and after use. This will ensure maximum
cutting performance. Hold this trimmer away from your body in a downward position
and apply oil on the front and sides of the blade. Wipe excess oil off with a soft dry
cloth.
Any other servicing should be performed by an authorized service representative, since
this appliance has no other user serviceable parts. This product is for professional use.
BAB831C IB-11_631C.indd 7-8
LUBRICATING THE BLADE
You should lubricate the blade with BabylissPro lubricating oil provided in your kit. Turn
the trimmer to "I-ON" position and hold it so the blade is pointed downward. Spread
one drop of oil across the blade, then turn the unit to "O-OFF" position and wipe away
the excess oil with a soft cloth. After cutting wet hair, clean the blade and apply a small
drop of BabylissPro lubricating oil.
Be careful not to use too much oil and don't oil your trimmer more than necessary,
as this could damage the motor (never attempt to oil the motor bearing, as it is
permanently lubricated). After oiling the blade, return the unit to the charging base.
Keep oil out of reach of children.
BLADE CARE
Because the blade set is precision-made for a very special use, it should always be
handled with care. Each time you finish using the trimmer, take the cleaning brush
provided and brush away any loose hair and debris. Replace the blade guard onto the
blade. Then store the unit to protect the blade until next use.
Be careful especially when changing or adjusting the blade set. When you have your
trimmer serviced, be sure that the blade set is sharpened or replaced at the same time.
REMOVAL/REPLACEMENT OF BLADE SET
To remove blade set from your trimmer, make sure that the
switch is in the "0-OFF" position and unplug trimmer from
electrical outlet. Remove the blade set by placing thumb
against the smaller cutter and pushing forward, releasing
the cutter from the trimmer housing. Replace with new
cutting system and reverse the removal procedure, only
this time place your thumb on the large cutter and snap
it into place.
1/28/15 2:27 PM