Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3-Wire Cable from Power Supply to 3-Wire Cable
from Cooktop
IMPORTANT: Use the 3-wire cable from power supply where
local codes permit connecting the frame-ground conductor to
the neutral (white) junction box wire.
A
B
C
D
E
A. 3-wire cable from power your
cooktop
B. Red wire from power supply
C. White wire from cooktop
cable
D. Green (or bare) ground wire
from cooktop cable
E. 3-wire cable from cooktop
1. Connect the red wire (B) to the white wire (C) from the
cooktop cable using a UL listed wire connector.
2. Connect the green (or bare) cooktop cable wire (D) to the
white (neutral) wire (G) in the junction box using a UL listed
wire connector.
3. Connect the 2 black wires (I) together using a UL listed
wire connector.
4. Install junction box cover.
F
G
H
I
J
F. Junction box
G. White wire from power supply
H. UL listed wire connector
I. Black wires
J. UL listed or CSA approved
conduit connector with wire
bushing
Complete Installation
1. Check that all parts are now installed. If there is an extra
part, go back through the steps to see which step was
skipped.
2. Check that you have all your tools.
3. Dispose of/recycle all packaging materials.
4. Use a mild solution of liquid household cleaner and warm
water to clean cooktop before use. Dry thoroughly with a soft
cloth. For more information, see the "Cooktop Care" section
of the Use and Care Guide.
5. Read "Cooktop Use" in the cooktop Use and Care Guide.
6. Reconnect power.
NOTE: If the cooktop does not work after turning on the power,
check that a circuit breaker has not tripped or a household fuse
has not blown. See "Troubleshooting" section in the Use and
Care Guide for further information.
If you need Assistance or Service:
Please contact the dealer from whom you purchased your
cooktop.
7
Publicité
Table des Matières
