Filling With Water - Fagor Xperta CAT 44 NG Manuel D'utilisation

All manuals and user guides at all-guides.com
GB
4 Overview of the menu
points
Below is an overview of the menu
points in which you can change and
save the machine parameters which are
preset at the factory and also start
programs and call up information. You
will find detailed information on this in
the further chapters of these operating
instructions.
• Menu «LANGUAGE»
Display language; Several languages
are available for selection.
Factory setting: «ENGLISH
• Menu «TEMPERATURE»
Programmable coffee temperature
between 1 (moderately warm) to 5
(extra hot).
Factory setting: 3 (normal).
• Menu «SHUT OFF TIME»
Programmable switch-off time
between 1 to 5 hours.
Factory setting: 1h (1 hours).
• Menu «WATERHARDNESS»
Programmable hardness level between
1 (soft) and 4 (very hard).
Factory setting: 4.
• Menu «CLEAN»
Start the cleaning program.
• Menu «DESCALE»
Start the descaling program.
• Menu «RESET»
Reset the changed parameter settings
to the factory settings.
• Menu «INFO»
Retrieve the number of cups of coffee
dispensed and the cup measure for
each cup size.
5 Before using for the first
time
5.1 Setting Up and Connecting the
Coffee Machine
Place machine on a suitable horizontal,
stable, unheated and water-resistant
surface. Ensure there is good air circu-
lation.
Important! If the coffee machine is
brought into a warm room from a cold
environment, wait about two hours
before switching on!
We advise you to place the coffee
».
machine on a suitable mat to prevent
damage being caused by spray and
splashes.
Hold the bean container with the
marking at the „Unlock container"
position
The bottom opening of the bean con-
tainer must be closed (Fig. 4,a), if it is
not closed (Fig. 4,b), insert the tip of a
ballpoint pen in the small oval hole
(arrow) of the black ring with the
marking „TOP" and turn opening clock-
wise as far as the stop.
Now turn the bean container anti-
clockwise to the position „Coffee
beans"
the position „Powder"
Push the drip tray in, until it engages
on the right under the water tank
(Fig. 5).
Plug the coffee machine into an
earthed mains socket. Do not use a
socket that is not earthed!
If you do not need the full length of
the mains lead, open the cable com-
partment on the back of the coffee
machine, and stow away the unused
lead (Fig. 6).
5.2

Filling with Water

Each time before switching on the cof-
fee machine, check that there is water
in the water tank and refill if necessary.
The coffee machine requires water for
the automatic rinsing processes each
time the machine is switched on or off.
and set it in place (Fig. 4).
(Fig. 10) or further on to
(Fig. 14).