Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
FOR MODEL ZIDI240 WITH CUSTOM DRAWER PANELS AND HANDLES
THE INSTALLATION SPACE
IMPORTANT: Double-Drawer Refrigerators are
designed to be built-in only. They cannot be used
free-standing.
Locate
Outlet
10-1/2"
9"
9" Max.
34-1/2"-35"
Max.
1-1/2"
23-3/4" Min.
NOTE: Handles
not supplied.*
* Custom handle clearances may vary, depending on the
standoff of the custom handles.
The cutout depth should be 24"
The cutout dimensions shown allow for full drawer
extension.
NOTE: The unit is designed to be flush with the
surrounding cabinets.
Additional Specifications
• A 120 volt 60Hz., 15 or 20 amp power supply is
required. An individual properly grounded branch
circuit or circuit breaker is recommended. Install
a properly grounded 3-prong electrical receptacle
recessed into the back wall as shown. Electrical must
be located on rear wall as shown. NOTE: GFCI
(ground fault circuit interrupter) is not recommended.
SIDE-BY-SIDE INSTALLATIONS –
Custom Panel Models Only
For a complete refreshment center, install a Double-
Drawer Refrigerator beside a Beverage Center or Wine
Chiller/Wine Reserve.
• A side-by-side installation requires at least a 47-1/2"
wide opening. No trim kits required.
• Products must operate from separate, properly
grounded receptacles.
1" = 2.5 cm; 1' = 0.3 m
31-51545-6
Design Guide
8-1/2"
24"
1-1/2"
34-1/4"
to 34-3/4"
24-7/8"
23-3/4"
PRODUCT CLEARANCES
When installed
in a corner:
Double-Drawer
Allow 2-1/2" min. clearance between Double-Drawer and
adjacent cabinet, wall or other appliances. Allow 23-1/8"
min. clearance from the front for drawer opening.
NOTE: Custom handle clearances may vary depending on
the standoff of the custom handles.
• Test the drawer openings. Carefully open and close
the drawers. The drawers should not rub or catch on
adjacent cabinetry. Notify the installer if the drawers
make contact with cabinetry. NOTE: When installing
custom panels and handles, use above clearances as a
general guide but adjust according to the installation.
Choose the location:
• These products may be closed in on the top and
three sides as long as the front is unobstructed for air
circulation and proper access to the drawers.
• Do not install these products where the temperature will
go below 55°F (13°C) or above 100°F (37°C).
• These products are not designed to be stacked one over
the other.
Black or Stainless Steel Toekick Options
• These products are shipped with two toekicks, a stainless
steel and a black toekick. For shipping purposes, one of
the toekicks will be secured to the back of the unit and
the second will be installed, in place, on the unit. Keep
the unused toekick, and other unused or removed parts,
for future use.
10-1/2"
34-1/2"-35"
15"
47-1/2" Min.
* NOTE: Additional
clearances may be required.
Countertop
23-1/8" min.
Clearance for Door
Opening 2-1/2" min.
Locate
Outlet
10-1/2"
24"
14"
9"
9"
1-1/2"
5
Publicité
Chapitres
Table des Matières
