Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
STEP 2 INSTALL CUSTOM 3/4"
DRAWER PANELS AND
HANDLES (CONT.)
(ZIDI240 model only)
Install custom drawer panels and handles:
• Open drawers.
• Remove 2 screws holding each trim; lift trims off.
Retain screws.
Custom handles of your choice, supplied by your
cabinet maker, must be installed onto the overlay
panels before they are slid into the trims. Countersink
all screws into the backer panels. Screws cannot
protrude from the backer panels.
Screws Must
Be Countersunk
Into Panel
Custom
Drawer Panel
Slide overlay panels into the trims.
1" = 2.5 cm; 1' = 0.3 m
31-51545-6
Installation Instructions
•
•
Handle
STEP 2 INSTALL CUSTOM 3/4"
DRAWER PANELS AND
HANDLES
(ZIDI240 model only)
• Reinstall the side trims using the trim screws removed
earlier.
• Place the brushed decorative covers over the side trim
to hide the screw heads. Ensure side trim is aligned
top to bottom and front to back. Snap into place.
NOTE: For shipping purposes, the brushed decorative
cover will be secured to the front of the unit.
(CONT.)
7
Publicité
Chapitres
Table des Matières
