Beaba BABYCOOK Classic Notice D'utilisation page 7

CLEANING
• Always unplug the appliance before you start cleaning it.
• Immediately rinse the accessories that have come into contact with the food
under running water to prevent bacteria from forming.
• Descale the heating reservoir regularly using distilled white vinegar only. Ensuring
the device is cold and not connected to power supply, pour a mixture of 1/2
cup of water and 1/2 cup of distilled white vinegar into the heating reservoir.
Leave for the night and then empty. Repeat the operation if necessary until all the
mineral deposits have been removed. Plug in the device and then complete two
heating cycles using water only in the
heating reservoir (3 measures) in order
to rinse it well. Then clean the bowl and
accessories with warm, soapy water.
• Never use a chemical descaler or a
coffee machine descaler in the heating
reservoir.
• After you have cleaned the blade, make
sure that the gasket is properly back in place as picture above.
• BABYCOOK's accessories are not suited for sterilization.
RECOMMENDATIONS
• Never put the bowl on the pedestral without the food processor blades in place.
• Do not move the appliance or put a cover over it while in use.
• Never immerse the electrical pedestal unit in water.
• Keep BABYCOOK out of children's reach and always lock the bowl lid fully so
that the blade is inaccessible.
• Use BABYCOOK on a flat, stable surface.
• Plug BABYCOOK into an earthed 110 V outlet.
• Do not run BABYCOOK in cooking mode when the reservoir is dry.
• Do not fill the bowl above the fill line.
• Regularly check that the steam hole on the bowl is not blocked. Do not add
water to the cooking bowl before mixing. There is a risk of very hot liquid being
splashed when mixing.
• Never lean over the steam outlet hole during the cooking cycle (risk of scalding).
• Handle hot parts with great care.
• Regularly de-scale the heating reservoir.
• If you need to make a claim under the warrantly of this product, please note the product
number printed on the label located on the underside of the base of the product.
• Any repair of the device must be carried out under the guidance of an
authorized person.
Securing gasket to blade
7