Quick Start; 15-Pin Mini D-Sub - NEC MultiSync LCD1980SXi Mode D'emploi

Quick Start

To attach the MultiSync
1. Turn off the power to your computer.
2. For the PC or MAC with DVI digital output: Connect the DVI signal cable to the connector of the
display card in your system (Figure A.1). Tighten all screws.
For the PC with Analog output: Connect the 15-pin mini D-SUB to DVI-A signal cable to the
connector of the display card in your system (Figure A.2).
For the MAC: Connect the MultiSync Macintosh cable adapter to the computer, then attach the
15-pin mini D-SUB signal cable to the MultiSync Macintosh cable adapter (Figure B.1).
NOTE: Some Macintosh systems do not require a Macintosh cable adapter.
NOTE: To obtain the MultiSync Macintosh cable adapter call NEC-Mitsubishi Electronics Display of
America, Inc. at (800) 632-4662.
3. Connect the DVI signal cable to the connector on the back of the monitor. Place the video signal
cable (Figure C.1). Connect the VGA or DVI to Input 2.
NOTE: Incorrect cable connections may result in irregular operation, damage display quality/
components of LCD module and/or shorten the module's life.
Collect cables and keep them in the stand by attaching the cable cover. The cable cover can
be attached on the front or back side of tilt stand (Figure C.1, C.2).
Please check Tilt, Rise and Lower monitor screen and screen rotation when you manage cables.
4. Connect one end of the power cord to the AC inlet on the back of the monitor and the
other end to the power outlet (Figure C.1).
NOTE: If you use this monitor at AC125-240V, please refer to Recommended Use section of this
manual for proper selection of AC power cord.
NOTE: For the MAC with digital output: before turning on the MAC, the DVI Input mode must
be set to DIGITAL in DVI SELECTION of OSM by pressing SELECT button then CONTROL
button when the DVI signal cable is connected to the DVI-I connector (Input1) of the
monitor. Otherwise the MAC may not turn on.
5. The Vacation Switch on the left side of the monitor must be turned on. Turn on the monitor with the
front power button (Figure D.1).
NOTE: The Vacation Switch is a true on/off switch. If this switch is on the OFF position, the
monitor cannot be turned on using the front button. DO NOT switch on/off repeatedly.
6. Turn on the computer. No-touch auto adjust automatically adjusts the monitor to optimal settings
upon initial setup for most timings. For further adjustments, use the following OSM
• Auto Contrast (Analog input only)
Refer to the Controls section of this User's Manual for a full description of these OSM controls.
NOTE: For download information on the Windows
LCD monitor, refer to the References section of this User's Manual.
1980SXi
NOTE: If you have any problems, please refer to the Troubleshooting section of this User's Manual.
Figure A.1
LCD1980SXimanual060704.p65
LCD monitor to your system, follow these instructions:
®
• Auto Adjust (Analog input only)
® 95/98/Me/2000/XP INF file for your MultiSync
Figure A.2
3
3
®
Figure B.1
Macintosh
Adapter
Macintosh Cable Adapter (not included) Note: Some
Macintosh systems do not require a Macintosh Cable Adapter
6/10/04, 9:28 AM
controls: