SilverCrest SMW 900 EDS B4 Mode D'emploi page 127

Troubleshooting
PROBLEM
There is nothing on the
display 1.
The appliance does not
respond to pressing the
buttons.
The appliance does not
start the cooking/heating
process.
The turntable 3 makes a
loud noise when turning.
"E01" appears on the
display 1 and you hear
beeps.
"E02" appears on the
display 1 and you hear
beeps.
■ 124 │
GB
All manuals and user guides at all-guides.com
POSSIBLE CAUSE
The plug is not inserted into
a mains power socket.
The mains power socket is
defective.
The display 1 is defective.
The child safety lock is
activated.
The door is not properly
closed.
The turntable 3 is not cor-
rectly positioned on the axle.
The small rollers 4 and/or
the fl oor of the cooking area
are unclean.
The microwave has over-
heated.
There is a sensor error.
There is an error during the
heating up of the appliance.
POSSIBLE SOLUTIONS
Check the plug.
Try another mains power
socket.
Contact Customer Service.
Deactivate the child safety
lock (see section "Opera-
tion").
Close the door properly.
Insert the turntable 3 cor-
rectly into the cooking area.
Clean the rollers 4 and the
fl oor of the cooking area.
Terminate the current pro-
gramme immediately.
Remove the plug from the
mains power socket, open
the microwave door and
allow the appliance to cool
down.
Stop the programme and let
the appliance cool down.
Then restart the microwave.
If the error occurs again,
contact Customer Support.
Stop the programme and let
the appliance cool down.
Then restart the microwave.
If the error occurs again,
contact Customer Support.
SMW 900 EDS B4