Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
PARTS, TOOLS, MATERIALS
YOU WILL NEED THE FOLLOWING TOOLS AND MATERIALS FOR THE INSTALLATION:
Carton or other heavy material for covering the counter top.
Clear tape
(for taping the templates to the wall)
Saber saw (for cutting vent
holes for roof or wall venting)
Phillips screwdriver
Pencil
Flat blade screwdriver
Measuring tape (metal preferred)
Small side cutters or tin snips
•
If you have brick or masonry walls, you will need special hardware and tools.
•
The ductwork you need for the installation is not included. All wall and roof caps must have a back-draft damper
(shown on page 5).
Gloves
Stud finder or thin nail.
Keyhole saw (for the power cord hole)
3/8" and 3/4" wood drill bits
1/2" and 3/16"
drill bits
Plumb line
Duct Tape
Caulking gun
6
Electric drill
Publicité
Table des Matières
