Bosch HMV9302 Instructions D'installation page 18

Électroménagers four à micro-ondes avec hotte
Masquer les pouces Voir aussi pour HMV9302:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

STEP 6:
ATTACH THE OVEN TO THE WALL
5. Roof vented installation: See Figure 32
Install ductwork through the vent opening in the upper
cabinet. Complete the venting system through the roof
according to the method needed.
See "PREPARE THE VENTING SYSTEM," step 2 on
the page 8. Use caulking to seal exterior roof opening
around the exhaust cap. See Figure 6 on page 8.
6. Use power supply cord clamp to bundle the power
supply cord. Install the power supply cord clamp, using
a screw as shown in Figure 33, to inside of the cabinet.
7. To install the grease filter: Slide it into the slide slot,
then push up and toward oven center to lock.
See Figure 34.
8. Plug in the power supply cord.
9. Read your use and care manual, then check the
operation of your microwave oven.
damper
duct
18
Figure 32
power
supply
cord
clamp
Figure 33
Figure 34

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Hmv9303Hmv9305Hmv9306Hmv9307

Table des Matières