Replacing The Filters - Titan IMPACT 640 805-002 Mode D'emploi

18. For High Rider cart units, thread the siphon tube into the foot
valve and tighten securely. Make sure to wrap the threads on
the siphon tube with PTFE tape before assembly. Replace the
return hose into the hose clip on the siphon tube.
19. For Skid and Low Rider units, insert the elbow on the siphon
assembly into the bottom of the foot valve housing. Push the
retaining clip up into the groove inside the foot valve housing
to secure the siphon assembly in position. Thread the return
hose into the pump block and tighten securely.
20. Place the front cover on the pump housing and secure in
position using the four front cover screws.
21. Turn on the sprayer by following the procedure in the
"Operation" section of this manual and check for leaks.
NOTE: repacking kit P/N 704-586 is available. For best
results use all parts supplied in this kit.
© Titan Tool Inc. All rights reserved.
All manuals and user guides at all-guides.com

replacing the Filters

Pump Filter
Gun Filter
13
1. Loosen and remove the filter housing by hand.
2. Slip the filter off of the filter support spring.
3. Inspect the filter. Based on inspection, clean or replace the
filter.
4. Inspect the seal. Based on inspection, clean or replace the
seal.
5. Slide the new or cleaned filter over the filter support spring
with the adapter in place over the pin on the spring. Push the
filter into the center of the pump block.
6. Slide the filter housing over the filter and thread it into the
pump block until secure.
NOTE: The filter housing should be hand-tightened, but
make sure the filter housing is seated fully into the
pump block.
Filter support
spring
Seal
Pump
block
1. Move the gun trigger lock to the unlocked position.
2. Loosen and remove the handle from the gun body.
3. Turning clockwise, unscrew the filter from the gun body.
NOTE: Left-handed threads require turning the filter
clockwise to remove.
4. Turning counterclockwise, screw the new or cleaned filter into
the gun body.
5. Make sure the handle seal is in position and thread the handle
into the gun body until secure.
6. Move the gun trigger lock to the locked position.
NOTE: For more detail, part number information, and
complete assembly drawings, please see the LX-80II
Professional airless Gun Owner's manual (P/N 313-
2293).
Filter
Adapter
Filter
spring
Filter housing
Gun
Body
Filter
Handle
Seal
Handle
English