General Maintenance; Lubrication - Ryobi RTS10 Manuel D'utilisation

TO CHECK THE ALIGNMENT OF THE RIP FENCE
TO THE BLADE
See Figure 48.
The rip fence must be parallel to the saw blade and the miter
gauge grooves.
WARNING:
A misaligned rip fence can cause kickbacks and jams.
To reduce the risk of injury, always maintain proper rip
fence alignment.
 Unplug the saw.
 Raise the locking lever to permit the rip fence to be moved.
 Place a framing square beside the blade and move the
rip fence up to the square. Take the dimension on the rip
scale.
 Move the fence back and turn the framing square 180°
to check the other side.
 If the two dimensions are not the same, loosen the two
bolts on the fence and align it.
 Retighten the two bolts.
 Make two or three test cuts on scrap wood. If the cuts
are not true, repeat the process.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts could create a hazard or cause
product damage.
WARNING:
Always wear eye protection with side shields marked
to comply with ANSI Z87.1 during product operation. If
operation is dusty, also wear a dust mask.
WARNING:
Before performing any maintenance, make sure the tool
is unplugged from the power supply and the switch is in
the OFF ( O ) position. Failure to heed this warning could
result in serious personal injury.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
All manuals and user guides at all-guides.com
ADJUSTMENTS
MAINTENANCE
 Periodically check all clamps, nuts, bolts, and screws for
 Check the blade guard assembly.
 To maintain the table surfaces, fence, and rails,
 Protect the blade by cleaning out sawdust from
 Clean plastic parts only with a soft damp cloth. DO

LUBRICATION

All of the bearings in this tool are lubricated with a sufficient
amount of high grade lubricant for the life of the unit under
normal operating conditions. Therefore, no further lubrication
is required.
37 - English
FRAMING
SQUARE
BLADE
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken, or
destroy plastic which may result in serious personal injury.
tightness and condition. Make sure the throat plate is in
good condition and in position.
periodically apply paste wax to them and buff to provide
smooth functioning.
underneath the table and in the blade teeth. Use a resin
solvent on the blade teeth.
NOT use any aerosol or petroleum solvents.
RIP
FENCE
BOLTS
LOCKING
LEVER
Fig. 48