Ryobi RTS10 Manuel D'utilisation page 20

To install anti-kickback pawls:
 Press and hold the button on the right side of the anti-
kickback pawls.
 Align the slot in the pawls over the rear hole in the riving
knife.
 Push the pawl handle down snapping them into place
and release the button.
NOTE: Pull on the pawl handle to make sure pawls are
securely locked.
PAWL
HANDLE
BUTTON
ANTI-KICKBACK
PAWLS
CORRECT
INCORRECT
All manuals and user guides at all-guides.com
ASSEMBLY
TO CHECK AND ALIGN THE RIVING KNIFE AND
SAW BLADE
See Figures 16 - 17.
To check alignment of the riving knife:
 Unplug the saw.
 Raise the saw blade by turning the height/bevel adjusting
 Remove the anti-kickback pawls and blade guard
NOTE: Place framing square between carbide teeth and
 The saw blade and riving knife are aligned when the
If the riving knife is out of alignment with the saw blade,
adjustment is needed. The riving knife must be in alignment
front to back (horizontally) and top to bottom (vertically).
Fig. 14
Fig. 15
20 - English
handwheel clockwise.
assembly. Place a framing square or straight edge against
both the saw blade and the riving knife.
measure from blade. This step will insure framing square
is square against blade from the front to back of blade.
framing square contacts both the blade and riving knife
evenly with no gaps.
HEX
KEY
RIVING
KNIFE
FRAMING
SQUARE
Fig. 16