Scope Of Supply; Device Description; Setting Up The Device - Weller WHS M Mode D'emploi

English

3. Scope of supply

WHS M / WHS MC
Mains cable
Switching power supply
Soldering iron with RT 3 soldering tip
Safety rest
Operating instructions
Safety booklet

4. Device description

The Weller soldering station WHS M / WHS MC is a versatile
soldering station for performing professional repair work on
state-of-the-art electronic assemblies in the industrial
engineering sector as well as repair workshops and
laboratories.
Digital control technology and superior sensor and heat-
transfer technology guarantee precise temperature control
at the soldering tip. High-speed measured-value acquisition
provides for maximum temperature precision and optimum
dynamic temperature performance in load situations.
The required temperature setting can be adjusted between
100 °C – 400 °C. Setpoint and actual values are displayed
in digital form.
Application note for battery:
- Fully charge the battery prior to initial operation or longer
periods of disuse.
- Set the isolating switch to "I".
- It is advisable to fully charge the battery at least once
a month.
- Store and use the battery at room temperature.
- Before storing the device for long periods, charge the
battery to a minimum charge of 50 % and set the
isolating switch (6) to "0".
- The standby function adapts the device according to the
mode of use and may increase the battery service life.
4.1 Safety rest
Attach the holder spring (12) with funnel insert (11) by
inserting the clamp on the holder spring in the recess on
the safety rest (13).
Soak the cleaning sponge in water and place in the sponge
insert (14).
7
4.2 Technical data WHS M / WHS MC
Dimensions:
Weight:
Mains voltage:
Power consumption:
Safety class:
Safety class
(switching power supply)
Temperature control:
Temperature accuracy: ± 9°C (± 17 °F)
Temperature stability:
Operating range:
Storage temperature:
Rel. air humidity:
Note the following specifications when using the
battery:
Maximum operating height:
3,000 m above sea level, no pressure compensation
Maximum storage height:
4,500 m above sea level, no pressure compensation
Maximum transportation height:
10,500 m above sea level, no pressure compensation

5. Setting up the device

WARNING!
Electric shock and risk of burns
Connecting the control unit incorrectly poses a risk of
injury and damage to the device. Risk of burns from the
soldering tool while the control unit is operating.
■ Read the enclosed instructions, the safety instructions
included in these operating instructions as well as
the instructions for your control unit all the way through
and observe the specified precautionary measures
before operating the control unit.
■ Always place the soldering tool in the safety rest
when not in use.
1. Carefully unpack the device.
2. When fitting the new soldering tip, make sure that
the soldering tip is inserted all the way up to the stop
in a single smooth action. Operating the soldering iron
with a soldering tip that is not fully inserted can cause
malfunctions.
Important:
Always ensure that the soldering tip is seated
properly.
3. Place the soldering tool in the safety rest.
L x B x H (mm): 133 x 110 x 55
L x B x H (inch): 5.24 x 4.33 x 2.17
approx. 2.0 kg
100 V to 240 V
50 Hz to 60 Hz
50 W
III
: II
100 °C – 400 °C (200 °F – 750 °F)
± 5°C (± 9 °F)
10 °C – 35 °C (50 °F - 95 °F)
-24 °C – 45 °C (-75 °F - 113 °F)
0 % - 90 %, not condensing