Instruction For Use; Accessories; Scope Of Supply - Weller WSD 81 Mode D'emploi

5. Instructions for use
For initial heating, coat the selective tinnable tip with solder.
This removes any oxidation or dirt on the tip which may have
occurred during storage. During pauses between soldering
and before storing the soldering iron, ensure that the tip of
the soldering iron is well coated. Do not use aggressive flu-
xing agents.
Note:
Always ensure the proper position of the soldering iron
tip.
These soldering irons have been adjusted for an average-
size tip. Deviations can occur due to exchanging of the tip or
using other tip designs.
External input unit WCB 2 (optional)
The following functions are possible when using an external
input unit.
● Offset:
The real temperature of the soldering iron
can be changed by ± 40 °C by input of a
temperature offset.
● Setback:
Reduction of the setpoint temperature to
150 °C (standby). The setback time can be
set at 0-99 minutes after the soldering
station has switched to standby mode. After a
period equal to three times the set-back time,
the "Auto Off" function is activated.
The soldering iron is switched off (flashing
dash on the display).
● Lock:
Locking the setpoint temperature. Settings
cannot be changed after the soldering station
has been locked.
● °C/°F:
Switching the temperature display from °C
to °F, and vice versa.
● Window:
Limitation of the temperature range to max.
±99 °C based on a locked temperature
resulting from the "LOCK" function. The
locked temperature represents the median
point of the adjustable temperature range.
For units with a floating contact (optocoupler
output) the "WINDOW" function is used to
adjust a temperature window. If the actual
temperature is within the temperature win-
dow the floating contact will be enabled
(optocoupler output).
● Cal:
Re-adjustment of the soldering station
(WCB 2 only).
● PC interface: RS232 (WCB 2 only).
● Temp. gauge: Integrated temperature gauge for ther
mal element Type K (WCB 2 only).

6. Accessories

T005 29 180 99 Soldering iron set WP 80
T005 29 161 99 Soldering iron set WSP 80
T005 33 131 99 Soldering iron set MPR 80
T005 33 112 99 Soldering iron set LR 21, antistatic
T005 33 113 99 Soldering iron set LR 82
T005 33 155 99 Soldering iron set WMP
T005 33 133 99 Soldering iron set WTA 50
T005 27 028 99 Preheating plate WHP 80
T005 25 032 99 Thermal insulating unit WST 82 Kit 1
T005 25 031 99 Thermal insulating unit WST 82 Kit 2
T005 31 180 99 External input unit WCB 2
T005 15 161 99 WDH 10T Switching holder
WSP 80/WP 80
T005 15 162 99 WDH 20T Switching holder WMP

7. Scope of supply

WSD 81
Control unit
Soldering iron WSP 80
Power cable
Operating instructions
Soldering iron rest
Jack (not USA)
Safety Information
Illustration: Circuit diagram, see Page 75.
Illustration: Exploded view, see Page 76
Subject to technical change without notice!
See the updated operating instructions at
www.weller-tools.com.
English
PUD 80
Control unit
Power cable
Operating instructions
Jack (not USA)
Safety Information
15