Setting The Power Level - Hilti TE 70-AVR Mode D'emploi

Masquer les pouces Voir aussi pour TE 70-AVR:
Table des Matières

Publicité

Emission sound pressure level (L
Uncertainty for the sound pressure level
(K
)
pA
Total vibration
Hammer drilling in concrete (a
Chiseling (a
)
h,Cheq
Uncertainty (K)
5
Operation
5.1
Fitting the side handle
CAUTION
Risk of injury! Loss of control over the combihammer.
▶ Check that the side handle is fitted correctly and tightened securely. Check that the clamping band is
engaged in the groove provided on the tool.
▶ Fit the side handle.
5.2
Fitting / removing the accessory tool
The use of unsuitable grease may cause damage to the tool. Use only genuine Hilti grease.
Always check the accessory tool for damage and uneven wear before each use; replace if necessary.
▶ Fit or remove the accessory tool, as applicable.
5.3
Drilling without hammer action
Drilling without hammer action is possible when accessory tools with a special connection end are
used. Tools of this kind are available from the Hilti tools range.
When the keyless quick-release chuck is fitted, smooth-shank drill bits for wood or steel, for example,
can be used to drill without hammer action.
▶ Set the function selector switch to the "Hammer drilling" position
5.4
Mixing
4
Use the mixing paddle only with the quick-release chuck.
▶ Set the function selector switch to the "Hammer drilling" position
the quick-release chuck.
5.5

Setting the power level

TE 70-ATC/AVR
TE 80-ATC/AVR
Power can be set only when the tool is switched on and ready for use.
To set the tool to half power, press the "half power" button. The power indicator lights up to indicate
reduced power. Press the "half power" button again to switch to full power. The power indicator goes
out.
Switching the combihammer off and then on again resets the tool to full power.
*2063038*
Printed: 30.08.2019 | Doc-Nr: PUB / 5150761 / 000 / 04
TE 70­AVR
)
102 dB(A)
pA
3 dB(A)
TE 70­AVR
)
10 m/s²
h, HD
9 m/s²
1.5 m/s²
2
3
4
2063038
TE 70-ATC/AVR
TE 80-ATC/AVR
102 dB(A)
102 dB(A)
3 dB(A)
3 dB(A)
TE 70-ATC/AVR
TE 80-ATC/AVR
10 m/s²
7.5 m/s²
9 m/s²
7 m/s²
1.5 m/s²
1.5 m/s²
.
and insert the mixing paddle into
English
17

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Te 70-atc/avrTe 80-atc/avr

Table des Matières