Amana Distinctions ACF3315A Manuel Du Propriétaire page 9

Burner should ignite within 4 seconds. If burner does not ignite within
4 seconds, turn control knob to OFF position and follow directions in
Placing Burner Caps section.
1. Push in and turn knob to LITE.
• Burner should ignite within 4 seconds.
2. After gas ignites, turn control to desired
setting.
• Knobs do not have distinct 'clicks'.
• Use HI to bring food to boiling
temperatures. When food is boiling
temperature setting should be reduced.
• After lighting burner do not operate for
long periods of time without cookware on
grate. The finish on the grate can chip
without cookware to absorb the heat.
• Flame size should match the size of the pan. Do not allow the flame
to extend up the sides of the pan. This can cause clothing to ignite,
make the handle hot, or cause burns.
3. When finished cooking, turn control to OFF position.
SURFACE BURNER
CONTROL SETTINGS
LO
MED
HI
• While turning burner control knob, watch the burner flame.
• Flame size should match the size of the pan.
• Flames that extend up the sides of the pan can ignite clothing,
making the handle hot, or cause burns.
WHEN TO USE SETTING
Use to prepare food at less than boiling
temperatures or to simmer.
Use to maintain boiling of larger
amounts of food, low temperature frying
and to maintain correct pressure in a
pressure cooker.
Use to bring food to boiling
temperatures. When food is boiling
temperature setting should be reduced
to LO through MED.
!
WARNING
To avoid risk of serious personal
injury, property damage, or fire,
do not leave surface burners
unattended while in operation.
Grease and spillovers can ignite
causing a fire.
The control descriptions are
intended to show the variety of features
that are available in the product line. If
your range does not have all the features
that are shown, it is not a mistake. The
information provided applies to several
of the available models.
Although the system that lights the
burners is electric, surface burners can
be ignited during a power outage. Never
attempt to light bake or broil burners
(oven burners) during a power failure.
1. Hold match at base of desired
surface burner.
2. Push in burner control knob and
turn to LITE position.
3. After gas ignites, remove match
from burner and turn burner control
knob to desired setting.