1. Fully open oven door.
2. Push hinge locks down toward door
frame, to the unlocked position.
• This may require a flatblade
screwdriver.
3. Firmly grasp both sides of top of oven
door.
4. Close door to first stop position.
5. Lift door up until hinge arm is clear of
the slot.
1. Grasping door top firmly, seat indentation of hinge arm into bottom edge
of the hinge slot.
• Door should be at the first stop position angle.
2. Fully open oven door.
3. Push hinge locks up against the front frame of the oven cavity to locked
position.
4. Close oven door.
1. Slide drawer out until it stops.
2. Remove stored items.
3. Grasp drawer sides near back of
drawer.
4. Lift up and out. Reverse to
reinstall.
!
CAUTION
To avoid personal injury or
property damage, handle oven
door with care.
• Do not lift door by handle.
• Door is heavy and can be
damaged if dropped.
• Screwdriver can scrape or
chip range or oven finish.
• Do not scratch or chip glass
or twist door. Glass may break
suddenly.
Not all areas of the oven are cleaned
by the self-clean cycle. The oven
door, the gasket and area
surrounding the gasket will not be
cleaned effectively by the self-clean
cycle. DO NOT use spray cleaners
to clean the outside or inside of the
oven door.
DO NOT clean the gasket. Do not
wet, rub, soak or use any type of
cleaning material to clean the oven
gasket. Any damage or defects
occurring from attempting to clean or
remove the gasket are not covered
by warranty.
To clean the area around the gasket
make sure oven is cool to the touch.
Using a cloth with a mild soap wipe
area needing to be cleaned. Avoid
gasket. Gasket should not be
removed while cleaning. Do not allow
water or cleaning solution to spill or
drip onto gasket.