Hahnel MODUS 600RT MKII Mode D'emploi page 25

Once all slave units are DCM matched, reboot all master and slave's by
turning OFF/ON
• Once all devices are DCM matched they will memorieze the unique ID
even it power is removed. Therfore you only need to DCM your set once
• If you add more speedlights or Viper TTL units to your range then you
need to carry out the DCM matching for all your units again
Modus 600 RT - Reset
ETTL Fully Automatic Wireless Flash
Shooting
Basic Automatic Wireless Flash shooting with a
Single Slave Unit
Modus 600RT - English
OK
4. A red LCD will show "Slave
OK". This slave Modus 600 RT
is now DCM matched
5. DCM match the same way,
any additional slave Modus
600RT while the Master is
still on
• To reset the Modus 600RT to
factory default settings press
function buttons 3 & 4 at
the same time and hold until
the LCD shows <
> release the buttons
• When the Modus 600RT is
reset the DCM is also reset
back to open channel and the
previous DCM is lost
1. Master Unit Setting
• Attach a Modus 600RT to
the camera and set it as the
master unit (Page 27)
• The Viper TTL Transmitter
can also be used as a master
unit to control the wireless
slave Modus 600RT (Page
42)
2. Slave Unit setting
• Set the slave Modus 600RT
to <
SLAVE
(Page 27)
3. Position of camera and
speedlight
• Position the camera with the
master unit attached and
the Modus slave within radio
range
4. Set the master unit flash
mode to <ETTL>
• Check that the master unit is
set to <ETTL>. If not press
RESET
> setting
25