Moving Parts; Operating Times; Ordering Spare Parts; Disposal And Recycling - EINHELL GE-TM 102 B&S Instructions D'origine

by anyone but a specialist.
Use only original replacement parts.

7.2.6 Moving parts

Maintain the moving parts and bearings at regular
intervals (after every 25 hours in operation). Pro-
ceed as illustrated in Fig. 55-57, in order to provi-
de the moving parts and bearings with optimum
protection against wear.
7.2.7 Repair
After carrying out repair or maintenance work, en-
sure that all safety parts are installed and in per-
fect condition. Store potentially hazardous parts
out of the reach of other persons and children.
Important: In accordance with the German
Product Liability Act, we are not liable for any
damages if they result from improper repairs
to the product or if parts are replaced by items
other than genuine parts or parts approved by us.
Furthermore, we are not liable for any damages if
they result from improper repairs to the product.
Arrange for your customer service or an autho-
rized workshop to do the work. The same applies
to accessory parts.

7.2.8 Operating times

Please note that the statutory regulations may
diff er from town to town.
7.3 Preparing the mower for long-term sto-
rage
Warning: Do not empty the petrol tank in enc-
losed areas, near fi re or when smoking. Petrol
fumes can cause explosions and fi re.
1. Drain the petrol tank using a petrol extraction
pump.
2. Start the engine and run it until the tank and
fuel line are completely empty and the engine
stalls.
3. Be sure to clean the entire equipment to pro-
tect the paint.
4. Store the equipment in a well-ventilated place
or location.

7.4 Preparing the mower for transport

1. Drain the petrol tank using a petrol extraction
pump.
2. Always let the engine run until it has used up
the remainder of petrol in the tank.
3. Empty the engine oil from the warm engine.
4. Remove the spark plug boot from the spark
plug.
5. Clean the housing and mower unit.
Anl_GE_TM_102_BS_SPK7.indb 29 Anl_GE_TM_102_BS_SPK7.indb 29
GB

7.5 Ordering spare parts

Please provide the following information when
ordering spare parts:
•
Type of unit
•
Article number of the unit
•
ID number of the unit
•
Spare part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info

8. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
- 29 -
26.11.15 08:36 26.11.15 08:36