Bosch TES 503 Serie Mode D'emploi page 18

14
2. Clean the individual parts with a deter-
gent solution and a soft brush. If neces-
sary, soak in a warm detergent solution.
3. Rinse all parts with clear water and dry
them.
4. Reassemble all the parts and replace
fully in the appliance.
¡
Risk of scalding!
Use this appliance only after the milk frother
(6) has been fully assembled and installed.
Cleaning the brewing unit
Clean the brewing unit regularly.
To pre-clean the brewing unit automatically:
e
1. Select by turning the rotary knob (14).
2. Place an empty glass under outlet (7).
3. Press the start button (10).
The appliance rinses.
Robert Bosch Hausgeräte GmbH
All manuals and user guides at all-guides.com
In addition to the automatic cleaning pro-
gramme, the brewing unit (5a) should be
removed regularly for cleaning (see figure E
at the start of the operating instructions).
1. Switch the appliance off at the power
2. Open the door (5b) to the brewing unit.
3. Slide the red lock (5e) on the brewing
4. Press the eject lever (5d) down fully.
5. Grasp the brewing unit (5a) by the
6. Remove the cover (5f) of the brewing
7. Thoroughly clean the brewing unit sieve
on/off switch O / I (9). No buttons are lit.
unit (5a) completely to the left.
The brewing unit is released.
recessed grips and remove carefully.
unit and rinse the brewing unit (5a) thor-
oughly under running water.
under the running water.
en