Trim; Landing; Maintenance - XciteRC FunSky RTF orange Mode D'emploi

Trim · Landing · Maintenance

Trim

Mode 1
Left
Right
Descend
Left Right Left

Landing:

• Go with slight throttle and rudder movements in slight descent towards the landing spot. Try, if possible
„soft" to land the model to spare. Try to land „smooth" without damaging the plane.
• NOTE: if the flight battery runs empty, the model does not respond accurately to your commands,
the flight is unstable. In this case land immediately.
• After landing switch of the plane and then the transmitter.

Maintenance

To have fun with your model over a long period, occasional service work is required to get your model in good
condition and to minimize wear.
• Remove dirt or dust depending with compressed air or a soft brush after each use. For stubborn dirt, a
harder brush or a toothbrush can be used.
• To clean the body/fuselage no chemical cleaners such as thinners may used, as this damage the plastic
of the body/fuselage. Normally a piece of soft cloth is ok, stubborn dirt can be removed with washing-up
liquid.
• Check the tightness of all screws and tighten if necessary.
• Also check all connections, cables and power battery / rechargeable battery for damage.
• WARNING: Damaged batteries or rechargeable batteries must not be used again and must be
disposed of immediately – fire hazard! Please note the disposal notes at the end of this manual.
• Check the model for worn, broken or jammed parts and gears and repair if necessary.
• WARNING: remove the batteries / rechargeable batteries of the transmitter and model when not in
use – fire hazard!
XciteRC FunSky
Mode 2
Turns left
Left
Right
Rudder
Ascend
Ascend
Elevator
Left side
Right
Aileron
Turns right
Descend
Right side
19