Air Design RAMA FLEX Manuel D'utilisation page 37

All manuals and user guides at all-guides.com
The RAMA FLEX has nylon wire support in the leading edge which cannot break, but if packed
badly (bending during packing) and stored for a long time may deform.
The AIRPack inner-bag can help you to pack easily and properly.
For details see the accessories section of the www.ad-gliders.com website.
Packing your AirDesign glider.
1. Lay the lines / risers / harness at the trailing edge of the wing. Collect the lines together and
lay them as much as possible on top of the wing fabric. This protects the lines during packing
and storage.
2. Starting either at one tip or at the centre of the wing, gather all the leading edge cell walls
together so that the polyamide rods are side by side.
IMPORTANT NOTE: if you are packing the glider on rough ground, first gather the wing into a
'cauliflower' by pulling in the lines and then pack the leading edge. Dragging the canopy over
rough ground will damage the fabric.
3. Lay the leading edge flat on the packing bag / Airpack and secure with the internal strap just
below the end of the polyamide rods.
4. Adjust the packed leading edge to ensure all polyamide rods are flat against each other.
5. Fold the rest of the wing in from the tips on each side using the same concertina procedure
and then fold one side half lengthwise on top of the other.
6. Fold the wing up from the trailing edge into 2 or 3 folds, removing excess air and making
sure that the packed leading edge is kept flat and outermost. DO NOT fold the leading edge
back inside the wing. This may damage / distort the polyamide rods.
7. For Packing bag - Undo the clip holding the leading edge in place and secure around the
folded glider. Close the bag with the side clip and top drawstring.