General Cleaning And Maintenance Work; Replace The Snow Shovel's Edge; Replace Rubber Rim On The Auger - Grizzly ASF 4046 L-Lion Set Traduction De La Notice D'utilisation Originale

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 24
All manuals and user guides at all-guides.com
Cleaning/Maintenance
Have work that is not described
in these instructions carried out
by a customer service centre
that we have authorised. Use
only original parts.
Switch off the device, remove the
safety key and remove the re-
chargeable battery from the device,
after all tasks.
General Cleaning and Mainte-
nance Work
Do not jet water onto the appli-
ance and do not clean it under
flowing water. This would result
in the danger of an electric
shock and the trimmer could be
damaged.
Keep the ventilation channels, motor
housing and handles of the machine
clean. Use a damp cloth or a brush to
clean them.
Do not use any cleaning agent or sol-
vent. This could damage the machine
irreparably.
Clean the ejector chute and the auger
of any snow residues after each use.
Prior to every use, check the appli-
ance for obvious defects such as
loose, worn or damaged parts. Check
that all nuts, bolts and screws are sit-
ting firmly.
Check the covers and protective de-
vices for damage and check that they
are sitting correctly. Replace them if
necessary.
Replace the snow shovel's
edge
1. Turn the machine on its side.
2. Release the 4 cross-head
screws (14a) on the snow shov-
el's edge (14) and replace them.
3. Insert the new snow shovel
edge (14) and screw it again.
Replace rubber rim on the
auger
1. Grasp the upper grip handle
(
1) and tilt the device back.
2. Release the 12 cross-head
screws, washers and nuts (32a)
on the 6-part rubber rim (32)
and remove them from the au-
ger (15).
3. Insert the new rubber rims (32)
on the auger (15) and re-tighten
them.
Storage
Leave the machine to thaw and dry
before you store it.
Keep the equipment dry and out of
reach of children.
Do not wrap plastic sacks around the
appliance as this could result in the
formation of moisture and mould.
Remove the rechargeable battery from
the device before storing the device.
Store the battery only in a partially
charged state. The state of charge
should be 30 – 50 % over a longer
storage period (Displayed charge sta-
tus
).
During a longer storage period, check
the state of charge of the battery and
recharge if necessary roughly every
3 months.
GB
71

Publicité

Table des Matières
loading

Table des Matières