Practical Tips; Switching The Light On And Off; Removing Obstructions And Blockages - Grizzly ASF 4046 L-Lion Set Traduction De La Notice D'utilisation Originale

GB
1. Insert the safety key (23) into
the device and turn it to the „I"
position (see small photo).
2. To switch on press
the release button
(22) while holding
down the start han-
dle (2). Disengage the release
button.
The auger (
turn.
2. To switch off re-
lease the start han-
dle (2).
4. After concluding work, turn the
safety key (23) to position „0".
Remove the safety key to pre-
vent unintentional starting.
Overload protection: The motor will
switch off automatically, if the ma-
chine is overloaded. Release the
start handle and start the machine
again after it has cooled down.

Practical tips

Observe the noise protection and
local regulations.
• Work with care, especially if you
change the movement direction.
• Move the machine slowly (at walk-
ing speed) and in lines which should
be as straight as possible so that the
lines overlap a bit.
• We recommend that the machine may
be used for snow heights of up to
20 cm.
• Clear snow when it is loose, freshly
fallen, as the layer of snow can turn
to ice later, making the work more dif-
ficult.
70
All manuals and user guides at all-guides.com
STOP START
1
I
3 2
15) will start to
STOP
3
• Do not use the machine with snow
that is very hard and frozen. The rub-
ber covering of the auger could be
damaged.
• Clear the snow in the wind direction
as far as possible.
• Switch the machine off and tilt it, if you
have to cross a gravel path or sensi-
tive surfaces.
• The carry handle (
machine easier to transport.
• Allow the motor to run for a short period
START
of time after you have completed the
1
I
work so that any moisture is removed
2
and no moving parts can freeze.
• Clean the machine after each use, as
described in the section "Cleaning/
Maintenance".

Switching the light on and off

The light only works while the machine is
in operation.
1. To switch on the light (4), place
the on/off switch (3) in position "I".
2. To switch off the light (4), place
the on/off switch (3) in position "0".
Removing obstructions and
blockages
Switch off the device, remove the
safety key and remove the re-
chargeable battery from the device,
before eliminating clogs in the ejec-
tor chute.
Snow can block the auger or the ejector
chute.
• Remove any blockages carefully with
a piece of wood or plastic.
Do not use any hard or sharp objects,
as these could damage the machine.
17) makes the