Data Plate - Dometic MaCave A 25 G Notice D'utilisation

IntroductIon
Thank you for choosing the Dometic wine cellar.
Please read the instructions carefully before
installing your new wine cellar. We trust that you
will be completely satisfied with your purchase.
The wine cellar must be installed and used ac-
cording to these instructions in order to operate
correctly and economically.
This appliance is intended to be used exclusively
for the storage of wine.
This appliance is intended to be used in house-
holds, restaurants and other residential-like ap-
plications.
This appliance is not intended for use by per-
sons (including children) with reduced physical,
sensory or mental capabilities, or lack of experi-
ence and knowledge, unless they have been given
supervision or instruction concerning use of the
appliance by a person responsible for their safety.
Children should be supervised to ensure that they
do not play with the appliance.
Do not store explosive substances such as aerosol
cans with a flammable propellant in this appli-
ance.
transIt damage
Inspect the wine cellar for transit damage. You
must report any damage the company responsible
for the delivery within the legal or stated time
for this type of product. If there is no such estab-
lished report time, the damage must be reported
within seven days of delivery.

data plate

Ensure you have received the
right model by checking the
data plate (located inside the
wine cellar at the top left).
The data plate shows details that you will need to
quote if you have to contact service personnel.
It is a good idea to make a note of them here:
Model designation . . . . . . . . . . . . . . . . . . . . . . . .
Product number . . . . . . . . . . . . . . . . . . . . . . . . . .
All manuals and user guides at all-guides.com
- 2 -
Serial number . . . . . . . . . . . . . . . . . . . . . . . . . . .
Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
InstallatIon
Please follow these installation instructions:
• For best performance, air needs to circulate
freely over the cooling unit behind the wine
cellar.
• The free-standing design of the cellar means
that it should stand at least 100 mm from the
rear and 50 mm from the side walls.
• Allow a clearance of at least 100 mm above the
wine cellar.
1. Remove the transport pallet on which
your wine cellar rests.
2. Adjust the feet to allow a 30 mm clear-
ance under the wine cellar. Verify that it
stands in a vertical position in both direc-
tions. Use a spirit level if necessary.
3. For optimum performance, please place
your wine cellar far away from any
source of heat (radiator, cooker or in-
tense sunlight).
4. Check that the charcoal filter is in place
at the top left corner inside the wine cel-
lar.
Wall
Rear
Wall