Main Burner; Rear Burner - BLAZE BLZ-4LTE2-NG Guide D'utilisation Et D'entretien

Fuel (Gas) Conversion Instructions for Blaze Gas grills.
CAUTION: This should only by performed by a licensed gas professional.
Main Burners:
You must remove all cooking grids and flame tamers to expose the main burners in the appliance.
1.
On the bottom rear of each burner is a cotter pin. Remove cotter pin.
2.
installation into an outdoor kitchen)
To remove burner, pull burner upwards and slide burner toward the rear of the appliance. Repeat for each burner.
3.
Where the burner was previously located, connecting to the main valve through the hole in the basin should now be
4.
empty space.
Inside the space you will find the end of the valve (toward the front of appliance), with an orifice (brass fitting),
5.
screwed into the end of the valve stem.
Carefully remove the orifice with a 6mm socket set and extension. (These are extremely fragile! When unscrewing,
6.
be extremely gentle, for you could easily break the brass fitting and have to replace the valve).
Once the old orifice is removed, replace it with the new orifice, (repeat for all burners). When re-installing the
7.
orifice, do not over tighten or you will strip the brass fitting. Very little pressure is needed!!!
Inspect burners for proper flame appearance. The ideal flame appearance is one that is mostly blue and not lifting off
8.
of the burner surface. There is an air shutter found at the end of the burner (close to the valve) which can be either
opened or closed to make adjustments to the flame's appearance. To adjust, remove the burner from the appliance
and loosen the Philips head screw holding the air shutter to the burner. If the flame is yellow, open the air shutter to
make the flame bluer. If the flame is lifting off of the burner surface, slightly close the air shutter. Re-tighten the Philips
head screw and re-install the burner to recheck the flame appearance. Repeat if necessary.

Rear Burner

For the Blaze 4 & 5 Burner, replace the back burner orifice by removing the plate on the rear of the BBQ and carefully
removing the fitting. Replace with the provided conversion back burner orifice – large brass fitting (differs from small main
burner orifice).
Blaze Instructional Book
Page | 35
(unless they were removed prior to