BLAZE BLZ-4LTE2-NG Guide D'utilisation Et D'entretien page 24

If the main burner cotter pins are removed before installing, the main burners must be double checked for the correct
placement in the grill before operation. When finished ensure that the burners are aligned with the valve orifice and seated
in the bracket slot. This is accomplished by first placing the burner tube shutter hole securely over the valve orifice and
ensuring the male post on the rear of the burner rests in the corresponding slot in the grill chassis. Failure to do so could
result in a fire and injury.
If the outdoor kitchen countertop will overhang the face of the island, notching out the two front countertop edges will be
necessary to allow the grill to slide flush against the outer front wall to the outdoor kitchen. Due to differing personal
preferences of the size of the notch out, this is recommended to be done at the point of installation so that the consumer can
dictate their preference.
NOTE: The control panel of this unit is removable for service and must remain accessible. Do not seal around the control panel
preventing removal.
Slide the appliance into the cut out and then attach the gas line.
•
Be very careful not to kink the gas line when lowering the appliance into the cut out.
•
Keep your fingers away from where the appliance will be supported on counter. Your fingers could
•
become trapped and serious injury could occur.
Check to make sure the appliance is level and is supported around the entire outside edge. If the
•
appliance is not level or is unstable, use non-combustible shims under the outside lip to stabilize it.
Perform the leak test procedure as described earlier in this manual.
•
Connect the transformer to the grill, then into the electrical outlet. Be sure to follow all of the electrical safety
•
and instructions found on page 12.
Blaze Instructional Book
Page | 24