Parkside PPS 40 A1 Traduction Du Mode D'emploi D'origine page 39

• Troubleshooting
Faults
Indicator lamp
does not lit up?
Ventilator does
not work?
Warning lamp
switches on?
No output
current?
Output current
does not
decrease?
Air current cannot
be regulated?
HF-arc is not
created?
Bad ignition?
Pistol is not ready
for operation?
All manuals and user guides at all-guides.com
Cause of fault
No electrical connection.
„
ON/OFF switch set to off.
„
Power line interrupted.
„
Power line ventilator faulty.
„
Ventilator faulty.
„
Overheating protection
„
switched on.
Input voltage too high.
„
Machine faulty.
„
Overvoltage protection
„
activated.
Input voltage too low.
„
Connection cable cross-section
„
too low.
Compressed air hose
„
damaged or faulty.
Valve/manometer fails.
„
The burner switch is faulty.
„
Soldering point on the burner
„
switch or plug loosened.
Valve/manometer fails.
„
Burner wear parts damaged
„
or worn.
Check HF spark gap.
„
Current switch is switched off.
„
Air transmission is restricted.
„
Workpiece is not connected to
„
the ground terminal.
Troubleshooting
Troubleshooting
Check power cable.
„
Set switch to ON.
„
Check power line.
„
Allow device to cool down.
„
Input voltage according
„
to type plate.
Machine must be repaired.
„
Allow device to cool down.
„
Observe input voltage
„
according to type plate.
New connection of the hose.
„
Renew electrode.
„
Change wear parts.
„
Set spark gap.
„
Switch the current switch to
„
'on'.
Another indication of this is
„
a green flame. Check the air
supply.
Check the connection.
„
GB/IE 39