Tips For Saving Energy - Whirlpool W84TI 31 X Mode D'emploi

Bubbling noise and splash: This noise is caused by the flow of the refrigerant in the tubes of the
system.
Water flow noise: Normal flow noise of water flowing to the evaporation container during defrosting.
This noise can be heard during defrosting.
Air blow noise (Normal fan noise): This noise can be heard during the normal operation of system
due to the circulation of air.
If humidity builds up inside the fridge;
• Is all the food packed properly? Are all containers thoroughly dried before placing them in the
fridge?
• Are the fridge doors opened frequently? Humidity of the room gets into the fridge each time the
doors are opened. Humidity build up will be faster if you open the doors more frequently, especially
if the humidity of the room is high.
• Build up of water drops on the rear wall after automatic defrosting is normal. (in Static Models)
If the doors are not opened and closed properly;
• Do the food packages prevent closing of the door?
• Are the door compartments, shelves and drawers placed properly?
• Are door gaskets broken or torn?
• Is your fridge on a level surface?
If the edges of fridge cabinet that the door joint contact are warm;
Especially in summer (hot weather), the surfaces that the joint contact may get warmer during the
operation of the compressor. This is normal.
IMPORTANT NOTES:
• If the appliance is switched off or unplugged, wait at least 5 minutes before plugging the appliance
in or restarting it in order not to damage the compressor.
• If the appliance is not used for long time (for example during holidays) defrost and clean the
refrigerator, leaving the door open to prevent the formation of midew and smell.
• If the problem persists after you have followed all the instructions above, please consult the nearest
Authorised Service.
• The appliance you have purchased is designed for home use and can be used only at home and
for the stated purposes. It is not suitable for commercial or common use. If the consumer uses the
appliance in a way that does not comply with these instructions, we emphasise that the producer
and the dealer shall not be responsible for any repair or failure within the guarantee period.
• The lifetime of your appliance stated and declared by the Department of the Industry is 10 years
(the period for retaining parts required for the proper functioning of the appliance).

Tips for saving energy

1. Install the appliance in a cool, well ventilated room, but not in direct sunlight and not near heat
source (radiator, cooker, etc...). Otherwise use an insulating plate.
2. Allow warm food and drinks to cool down outside the appliance.
3. When thawing frozen food, place it in the refrigerator compartment. The low temperature of the
frozen food will help to cool the refrigerator compartment when it is thawing. So it reduces the
energy requirements.
4. When placing, drinks and liquids they must be covered. Otherwise humidity increases at the
appliance. Therefore the working time gets longer. Also covering drinks and liquids helps preserve
the smell and taste.
5. When placing food and drinks, open the appliance door as briefly as possible.
6. Keep the covers closed of any different temperature compartment in the appliance (crisper, chiller,
etc...).
7. Door gasket must be clean and pliable. Replace gaskets if worn.
EN - 14