Electrical Warnings - Whirlpool W84TI 31 X Mode D'emploi

developing within the appliance.
INSTALLATION
The appliance must be handled
and installed by two or more persons
- risk of injury. Use protective gloves
to unpack and install - risk of cuts.
Installation, including water
supply (if any) and electrical
connections, and repairs must be
carried out by a qualified technician.
Do not repair or replace any part
of the appliance unless specifically
stated in the user manual. Keep
children away from the installation
site. After unpacking the appliance,
make sure that it has not been
damaged during transport. In the
event of problems, contact the dealer
or your nearest Aftersales Service.
Once installed, packaging waste
(plastic, styrofoam parts etc.) must be
stored out of reach of children - risk
of suffocation. The appliance must be
disconnected from the power supply
before any installation operation - risk
of electrical shock. During installation,
make sure the appliance does not
damage the power cable - risk of fire
or electrical shock. Only activate the
appliance when the installation has
been completed.
Be careful not to damage the
floors (e.g. parquet) when moving the
appliance. Install the appliance on
a floor or support strong enough to
take its weight and in a placesuitable
for its size and use. Make sure the
appliance is not near a heat source
and that the four feet are stable and
resting on the floor, adjusting them
as required, and check that the
appliance is perfectly level using a
spirit level. Wait at least two hours
before switching the appliance on, to
ensure that the refrigerant circuit is
fully efficient.
WARNING: To avoid a hazard
due to instability, positioning or fixing
of the appliance must be done in
accordance with the manufacturer
instructions.
WARNING: It's forbidden to place
the refrigerator in such way that the
metal hose of gas stove, metal gas or
water pipes, or electrical wires are in
contact with the refrigerator back wall
(condenser coil).
All dimensions and spacing needed
for installation of the appliance are in
the Installation Instruction booklet.
WARNING: When positioning the
appliance, ensure the supply cord is
not trapped or damaged.

ELECTRICAL WARNINGS

It must be possible to disconnect
the appliance from the power
supply by unplugging it if plug is
accessible, or by a multi-pole switch
installed upstream of the socket and
the appliance must be earthed, in
conformity with national electrical
safety standards.
Do not use extension leads,
multiple sockets or adapters. The
electrical components must not
be accessible to the user after
installation. Do not use the appliance
when you are wet or barefoot. Do
not operate this appliance if it has
a damaged power cable or plug, if
it is not working properly, or if it has
been damaged or dropped. If the
power cable is damaged, it must be
replaced with an identical one - risk
of electrical shock.
If the supply cord is damaged, it
must be replaced with an identical
one by the manufacturer, its agent
or similarly qualified persons in order
to avoid a hazard - risk of electrical
shock.
EN - 6