Braun ThermoScan IRT 6520 Mode D'emploi page 6

How to use your Braun ThermoScan
1
Remove the thermometer from the protective case.
2
Push the Power button
During an internal self-check, the display shows all segments.
Then the last temperature taken will be displayed for 5 seconds.
3
The lens filter indicator will blink to signal one is
needed.
To achieve accurate measurements, make sure a new,
clean lens filter is in place before each measurement.
Attach a new lens filter by pushing the thermometer
probe straight into the lens filter inside the box and
then pulling out.
Note: The Braun ThermoScan will not work unless a
lens filter is attached.
4
Select an age with the Age Precision
Press button to toggle through each age group.
NOTE: You must select an age in order to take a measurement.
The thermometer is ready to take a temperature when the display
looks like the image below.
.
button as shown.
™
0-3 Mos >3-36 M
5