Extel WECA 109058 Mode D'emploi Et D'installation page 28

2. FREE PASSING
You will find on the internal block, a latch behind the handle to block the latch bolt in "permanent
opening" position (hold the handle down and move the latch to the right side).
3. PARTICULAR NOTES
Before starting to install:
Check all elements work properly together.
Use the indicated code on the card supplied with the lock. The button must be freely turned by hand
and must return automatically thanks to its internal spring. The handle on the internal part must also
move freely.
If you lost the card with the code, note at the back of the keyboard the letters and/or the numbers
of pins shown in red. Press "C" and then the keys corresponding to the code, no order when num-
bering is requested.
The latch bolt must be easily opened by hand pressure or by inserting and turning the square in the
barrel. If you wish to modify the factory access code, we advise you to do it before installing the lock
(§ 6).
Reminder: Always start by pressing the "C" key to reset.
4. CHECK THE OPENING DIRECTION OF YOUR DOOR
Use the diagram below and note the right and left terms refer to the position of the hinges by
being outside whether the door opens inward or outward.
Right hand
All manuals and user guides at all-guides.com
Inside
Outside
3EN
Left hand