EN
DE
All manuals and user guides at all-guides.com
INSTRUCTION MANUAL VOSS.SONIC 2000
2. OVERVIEW OF THE DEVICE AND ITS FUNCTIONS
2.1 ASSEMBLY AND OPERATING PARTS
Solar panel
Speaker
Dial "Sensitivity"
LED flash
Motion detector
2.2. HOW VOSS.SONIC 2000 WORKS
The VOSS.sonic 2000 easily repels unwanted visitors. A combination of selectable ultrasonic frequencies and a flashing light
scares away even stubborn animals. As soon as the motion sensor is activated, the device starts to emit a series of ultrasonic
sounds based on the respective setting of the „Frequency" dial. The animals will not stay in the area where they can hear the
sounds, since they are very unpleasant to them. The sound will only be triggered if an animal enters the operational area.
This prevents the animals from becoming accustomed to the noise, which further increases the repellent effect.
This device does not guarantee a 100% success, since animals react differently to the ultrasonic signals.
Important notice
The repeller emits ultrasonic sounds that are inaudible or barely audible to humans. According to the current research,
ultrasound does not cause any damage if the maximum level is below 140 dB and the average level, based on 8 h/day,
is below 110 dB. Our devices emit ultrasonic sound with the noise levels ranging between 80 and 120 dB. Continuous
operation of the units is not possible. Ultrasonic waves can penetrate light building materials. The efficiency of the ultrasonic
signal behind solid objects is reduced. It may be necessary to set up several units to ensure complete coverage.
3. ASSEMBLY AND FIRST TIME OPERATION
The VOSS.sonic 2000 is powered by 3x AA 1.2V NiMh rechargeable batteries (already installed).
Choose a location for the VOSS.sonic 2000 so that the solar panel gets the most sunlight in order to recharge the batteries
effectively. To ensure best operation possible, we recommend to clean the solar panel regularly with a damp cloth.
For best effect, place this unit facing in the direction from which the animals come. VOSS.sonic 2000 is generally moisture
proof and can be used both indoors and outdoors. However, care should be taken when choosing a location, so that the
charging connection is protected and that there is no risk of permanent contact with water, rain or other liquids.
In dry area free from water, you can simply place the VOSS.sonic 2000 on the floor. For installation outdoors (e.g. in the
garden), we recommend using the supplied mounting post. Hanging holes on the on the back of the device allow wall
mounting. This way, you can use the VOSS.sonic 2000 anywhere you need it.
Outdoors the unit should be located approx. 15 cm above the ground. This ensures an ideal detection range and good
ultrasonic dispersion.
When choosing a location make sure the unit does not become a tripping hazard for other people.
Important tip
Insufficiently charged batteries cannot trigger the flash.
If the battery voltage is too low, the ultrasonic signal may also be affected.
If the batteries are too weak, they must be charged.
45022 | 10 | 2020 | V 2
FR
IT
NL
"Frequency" and
ON/OFF dial
USB connection
Opening for the
mounting post
SV
ES
PL
11